Ballards Grip Heaters

HEATED GRIP KIT

Mylar tape-stye heating element wraps attach under your favourite handgrips to provide toasty comfort at high or low temperature settings. If you ride in wet or cold conditions you know that safety and control of the motorcycle can be severely compromised by cold aching hands. Keeping those hands warm increases endurance and riding enjoyment 
(many riders claim that grip heaters help to reduce forearm pump which can result in numb hands and wrists). No need to wear big bulky gloves, now you will have no problem keeping your hands warm! The 12-volt system draws 36 watts of power. (Draws off coil type power supply).

Installation Instructions

1. Remove grips and clean off handlebar and throttle tube.
2. Remove backing from heat pads and stick to the left side handlebar and right side throttle sleeve with the wires at the top of the bars.
3. Lubricate heat pad and the inside of the grip with a contact adhesive or whatever you normally use to mount your grips and slide them on over the heat pads.
4. Mount switch wherever you require and follow the wiring diagram to hook up heat pads.
5. Note: be sure and leave enough loose wire on the throttle side so that when you turn the throttle it doesn't make the wires too tight and cause them to fail.
6. Check that after installation all lights and electrical components are working fully and correctly.

Please Note: Not suitable to be used with Lock On style grips.

Browse more

• Browse all Ballards
• Browse all Ballards Grips
• Browse all Heated Grips